Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: tivoi on August 15, 2006, 09:26:13 AM
-
I want use both LTP 1 and LTP 2, because i want use encoder for xyz axis. Need too much input, 1 LTP just have 5 input. If i use LTP 2 port I have more than 17 input. That right? ??? ??? ???
-
That sounds about right
-
any body try use 2 printer port? how to setting Mach3
-
Yes, you can use both. You need to make sure the port address for port 2 is right and that it is enabled.
Brett
-
thanks for your replay . but i had more question. address of LTP 2. where i can get it?
-
Look in control panel of windows then go to the system icon then hardware then device manager and look under ports. Right click your second port and go to the resources tab, the address will be the first four digits in the I/0 range.
Hood
-
thanks you very much :)
-
I want use both LTP 1 and LTP 2, because i want use encoder for xyz axis. Need too much input, 1 LTP just have 5 input. If i use LTP 2 port I have more than 17 input. That right?
Yeap. See picture
Scott