Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: kak on May 19, 2009, 03:09:08 PM
-
Hello
If I install the Mach3 on my home PC, without the router or BOB, will it work? I just want to play with screens.
Will it be possible to run a program without BOB and a router?
Adam
-
Yes you can. Make sure you reboot after install.
Ed
-
yes. i test all my programs and screens on my pc inside before i transfer outside to my mill pc.
not having your motor tuning etc setup properly will give your innacurate estimated runtimes and simulation speeds.and so forth, i would find someone running the same hardware as yourself with the same controller and use his xml file in your install.
I test clients files (and mine) like this when they crash their hardware. easier to see visually where something is going wrong that to pour through 100 000 lines of code.
-
Thanks
I have 2 machines in the basement and I live in an apartment on 4th floor - without elevator :-). So I just need to copy the XML file. Thanks
How about the printerport at home - I dont have one - just USB. Will it still work?
Adam
-
You dont need a printer port for simulation.
Hood