Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Mitchell_a10 on May 16, 2009, 08:01:36 PM

Title: servo control
Post by: Mitchell_a10 on May 16, 2009, 08:01:36 PM
All hardware and software installed, but no servo control from Mach3 to my DSLS 3000. I then enabled plug and play detection on the LPT1 but they only  "come to attention" and hold position. Tnere is no conflict on this port #1.  Any help appreciated, Thanks! PS... OS is XP Home
Title: Re: servo control
Post by: Jeff_Birt on May 16, 2009, 11:48:17 PM
Are you using the XML profile that Taig provided?