Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: thedude on May 07, 2009, 10:05:53 PM
-
Ive read several posts that talk about changing from one to the other,, but for the life of me,, cannot find it in the software!.
The manual is no help here either. Just sais what it does.
Can anyone describe how to set between the two?
-
You can change it in General Config, or use G64 for CV or G61 for Exact Stop.
-
Thanks!.... I dont see it in general config though,,,,Thats where I was looking, to find it. I'll shoot my self if it's there and I missed it...
-
:)
-
:)
Good gosh,,,, I guess I was drawn to lurking around the CV settings for it,,,,
Thanks,,!!!
-
The best way I think is to get into the habit of having the G61 or G64 in your code as this will override the settings in General Config and could catch you unawares if going from one job to the next without making sure it has been reset to default.
Hood