Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: mrpeja on April 30, 2009, 10:02:52 AM

Title: Floating head switchoffset
Post by: mrpeja on April 30, 2009, 10:02:52 AM

Hi all,
finally my floating head works fine. But I spent three days for this, until I realise what switchoffset really is.
I mentioned this is the travel between moments when switch is on and off, usually 0,5 - 1 mm.
But it isn't.
It includes complete travel of floating head holding plate, from the moment when torch touches material, to the moment when switch is activated. In my case - 16 mm.
I suppose I didn't precisely understood the explanations and texts I got. (I newer learned English in the school),
Thanks to everybody who helped me
mrpeja

Title: Re: Floating head switchoffset
Post by: dwyersm on April 30, 2009, 05:48:54 PM

mrpeja
 read what I have written to your other post, and what I posted as well.


regards,
 Shane Dwyer
 AU

Title: Re: Floating head switchoffset
Post by: mrpeja on May 01, 2009, 01:53:01 AM

Thanks Shene,
All advises I got was correct, but, my mistake, I didn't read enough carefully
mrpeja