Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: msraynsford on April 26, 2009, 05:47:11 PM

Title: Uninstall Mach3
Post by: msraynsford on April 26, 2009, 05:47:11 PM

I'm still having problems with my Mach3 not communicating with the parallel port so I tried to reinstall Mach3.
When I uninstalled Mach3 I just happened to have the DRO's at values other than zero, now when I reinstall the DRO's stay at the same value. This suggests to me that my uninstall didn't remove everything from my computer.
What do I have to do for a full uninstall? Am I missing some drivers or something similar?

Title: Re: Uninstall Mach3
Post by: Chaoticone on April 26, 2009, 08:28:09 PM

You can check to see if the driver was removed in device manager. It will say MachX pulsing engine. You can also delete the Mach 3 folder that is most likely on your c drive. If you have any profiles set up, screen sets or macros you want to keep, save a copy of those on a thumb drive or CD before you delete the folder.

Brett