Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: xnaron on April 24, 2009, 02:25:47 PM
-
I currently have mach setup to jog at 30% and to override I use the shift key and the arrows (or numberpad) to jog at the fastest possible as set in the motor config. I am adding a wireless bluetooth keypad for jogging but it does not have a SHIFT key. Is there anyway to map this to another key or some other way to allow slow/fast jogging using only the numberpad?
thanks,
BRendin
-
So either this is so easy to do that no one replied to a stupid question OR this can't be done. Anyone?
thanks,
Brendin
-
Not sure if KeyGrabber could be used for this or not, its been a long time since I have used it but might be worth a look. You should find it in the Mach3 directory on your computer.
Hood
-
Brendin,
When you get around to adding the keypad, open up "Keygrabber" (happy face icon) in the Mach 3 folder on your C: drive as Hood suggested.
I would think if it was going to work, it would show up under the "HID controllers" tab or possibly the other tabs since it's actually a keypad.
I won't be much more help as I've only used a game controller through KeyGrabber.
Dave
-
Thanks Guys.
I also found a way to change the windows key map in the registry. I need to wait until my bluetooth keypad gets here before I can try it. Will post results.
Brendin