Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: rceebuilder on August 06, 2006, 07:22:48 AM
-
I don't know if it is a problem or I do something wrong when I increase the feed rate Mach3 rounds the corners of the cutting path .It is related with the accelaration The more acc is decreased The more the corners is cut round. ???
Rceebuilder
-
That's a function of Constant Velocity mode. If you need sharp corners, use Exact Stop mode.
-
That is a CV problem... There is a way to tell mach 3 to only round so much... Go to the settings page and do the following settings:
CV angle = 45
CV feedrate = 30 anf turn it on...
If you would like to have less rounding make the CV feedrate lower