Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: JHChoppers on April 20, 2009, 06:09:57 PM

Title: Constant Lathe Spindle surface feed
Post by: JHChoppers on April 20, 2009, 06:09:57 PM

I have an 80's Mori Seiki SL-1 that I am planning on converting to MACH3.  Can Mach3 addjust the Spindle Speeds to provide a constant surface feed rate as the diameter changes ?

Thanks,
Joel

Title: Re: Constant Lathe Spindle surface feed
Post by: Hood on April 20, 2009, 06:13:38 PM

Yes.
Hood

Title: Re: Constant Lathe Spindle surface feed
Post by: JHChoppers on April 21, 2009, 09:59:26 AM

Thanks HOOD !