Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Sweeney on April 20, 2009, 04:48:43 PM

Title: Machine profile into Mach?
Post by: Sweeney on April 20, 2009, 04:48:43 PM

I just got a MIKINI mill and need to load it's profile into Mach.   Where do it go?   If it doesn't involve drilling a hole in my computer and dropping it in, I'm lost.

Thanks for any assistance.

Title: Re: Machine profile into Mach?
Post by: bowber on April 20, 2009, 04:53:14 PM

You need to copy the profile into the mach3 folder, this is typically on the C drive.

Steve

Title: Re: Machine profile into Mach?
Post by: Sweeney on April 20, 2009, 05:17:49 PM

Got it!  Thanks! Just trying to over complicate things here...