Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: rdespins on April 18, 2009, 09:25:10 PM

Title: Pendant?
Post by: rdespins on April 18, 2009, 09:25:10 PM
Anyone know if this unit could be used with mach 3?  http://www.axis.com/products/cam_295/
Title: Re: Pendant?
Post by: budman68 on April 19, 2009, 08:03:29 AM
I'm not saying it will definitely work, but since it shows up as a game controller, I would think you could setup the axis' and buttons through KeyGrabber- :)

Dave
Title: Re: Pendant?
Post by: rdespins on April 19, 2009, 02:17:17 PM
Thanks, I may give it a try if I can scoop one up on the cheap =).

Ron