Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: didjado on April 17, 2009, 12:52:49 AM

Title: cannot load the full gcode file into mach3...
Post by: didjado on April 17, 2009, 12:52:49 AM
Hi

i cannot load the complete g code file into the demo version of mach3... the file originates from DeskProto software

and at  the below... stops loading
G1 X8.584 Y8.216 F700
G1 X8.805 Y7.995

about 1/10 of the file is being loaded

any ideas... the file is attached
Title: Re: cannot load the full gcode file into mach3...
Post by: Overloaded on April 17, 2009, 01:01:06 AM
The Demo version is limited on the amount of code you can run.
Thats a BIG file.
RC
Title: Re: cannot load the full gcode file into mach3...
Post by: didjado on April 17, 2009, 04:31:42 AM
that expains it ...

thanks
Title: Re: cannot load the full gcode file into mach3...
Post by: Jeff_Birt on April 17, 2009, 08:49:01 AM
Yep, you just need to purchase a license to load a file that big. The demo allows you to run enough code to see how well it will work for your application, which I have always kind of liked. You can get purchase a license from the 'Support' tab on this site or from a Mach dealer. IHMO it is a great value.