Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: bfairey on April 08, 2009, 10:56:58 AM
-
It loads the Gcode ie Roadrunner but wont run it.
Which button do I push?????
The PC is not connected to a machine.
Brian.
-
Is the RESET flashing?
Hood
-
Do you have all the axis setup in ports and pins?
-
reset not flashing
port and pins set correctly
-
please attach your xml.
Hood
-
The only error I found was under Config check
Output signal check
Pin for output found as not pins 1-9, 14, 16 or 17 unless using "modbus"?????
This is wrong.
Please comment.
Brian.
-
please attach your xml
Hood
-
Hood did you get my XML file?
Brian.
-
nope
Hood
-
Try this
Brian.
-
Your xml runs it fine here, noticed you have a couple of pins set wrong. The DIR for Z and A are the same, ie pin 8, also you have OutPut 1 set to pin 0.
Neither of these would cause a problem with simulation however.
You have a non standard screen loaded, I am not sure where you got that from but that could well be the problem as the Start button may not be asigned properly, try going to the View menu and loading the standard 1024.set screen and see if that reslolves your problem.
Oh also not sure if its the Demo you are running, if it is you will only get 500 lines of the roadrunner showing but it will still run up to that 500 lines.
Hood