Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: RHOLLIDAY on April 08, 2009, 04:58:17 AM
-
Retrofitting a Sharp mill. I have the x-- limit and x home on one switch with a separate switch for x+. The limit override led is on.
When I reference x home, X goes to home and stops but will not back off the switch and the limit switch is triggered. To get off the
switch I have to turn off the X-- input. Then when I home it will home and zero the DRO but not move off the switch.
Same problem on the Y and Z
Robert
-
Try with the debounce interval at 2000 and if that halps lower it until the problem again appears and notch up again.
Hood
-
Thanks that fixed it. Now I will try to cut the roadrunner.