Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: davy182 on April 05, 2009, 10:49:38 AM
-
I know my machine needs repair but it isn't broken yet. I am only loosing .003 in one direction on the x axis, and I was wondering if you could have a forward and reverse setting for each axis. For example.
x axis 0 0.003
y axis 0 0
z axis 0 0
That way I can at least save some money up to repair the machine.
David
-
Compensate for backlash in: 'configure' -'backlash' - enable check-box. That is basically for total backlash - both directions.
Bill C