Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Willy on April 04, 2009, 01:28:28 PM
-
I have a very large machine that I am setting up and fine tuning and I do rectangular with 4 square corners test file run. On the Mach screen and the machine run with 3 round corners as you can see from the screenshot.
Can you please tell me what cause that?
Thanks
Willy
-
Probably CV mode.
-
Hi,
For external corners, I always prog to roll the cutter round the corner. Its much gentler on the machine?
Might also help with your problem?
ATB
Derek
-
Put a G61 at the start of your g-code, that should stop the rads.
Graham