Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: c1nel2 on December 30, 2005, 08:20:07 PM

Title: corel draw 12
Post by: c1nel2 on December 30, 2005, 08:20:07 PM

Art
If it was posible too import a DXF file from Corel Draw 12 into Mach 3 life would be a lot easier. I have found a work around but I can't use layers with the
work around.
I save as an Autocad 10 then open up the file in Turbocad learning edition then move the file to were it should be located in Mach 3 then exit and then save
as a turbocad file. It will then load in Mach 3 DXF import.  I will send a simple file that you can look at.
Thank You
Clay

Title: Re: corel draw 12
Post by: jemmyell on January 04, 2006, 06:08:45 PM

Hello,

I have a  custom DXF export written in VBA for CorelDraw 12.  It is currently posted on the SheetCAM group in my files folder 'jemmyell'.  It is open source and I would welcome further development on this.

-James