Machsupport Forum
Mach Discussion => FAQs => Topic started by: avirostick on April 03, 2009, 03:49:03 PM
-
I heard it was 150 or 500 or something. I got the trial last week, love it!! I made about 5 or six programs and they are not huge( mabye 20 to 40 lines each). I tried to put in an M30 command, because I was at the end of writing a program, and it wouldn't save that command. I wondered if The trial was running out. If I buy the whole version, do I have to wipe the trial download off first? Thank you for helping me. I really appreciate you fine folks. Take care!
-
HI, I think you only have to place the Licence file in your Mach3 folder in order to get it work.
Mach3 is limited to 500 lines of code in the trial version and this number is lower in the lathe mode
-
You have to hit the enter key after typing M30 or it won't get saved.
-
Thanks to both of you. It really helped me a lot. Take care.