Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Grumpy on March 18, 2009, 05:36:05 PM

Title: Univelpo Comp 3 Axis Driver Board
Post by: Grumpy on March 18, 2009, 05:36:05 PM

Can any one help to configure Mach to work with this Driver? I can get the motors to run with Manual control but nothing from the jog keys

Title: Re: Univelpo Comp 3 Axis Driver Board
Post by: Hood on March 18, 2009, 06:38:23 PM

Link to manual?
Hood

Title: Re: Univelpo Comp 3 Axis Driver Board
Post by: Grumpy on March 19, 2009, 07:19:40 AM

the manual was not much help.