Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: C.HENRY on March 16, 2009, 02:32:51 PM
-
I have mach3 R3.042.020 installed on my computer and for some reason, when I try to access CONFIG - MOTOR TUNING, nothing happen, I mean, the screen it used to show me, does not appear anymore ! So, does anyone know what I could do to fix this problem instead of re-install the program ? Thank you very much ???
-
Try reinstalling, you dont need to uninstal the setup you have now, you just reinstal over the top. Might also be worthwhile redownloading before you do it just in case the one you have is corupt.
Hood
-
How about trying a re-installation of Mach 3? Also download the latest version -------022
Bill C.
Hood is right there as usual! I was too slow..
-
Thank you Hood and BClemens for the suggestions. I will try it soon !