Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Milt on July 27, 2006, 11:51:56 AM
-
Hello veryone my name is Milt., I have question:
I have an old max nc controller, that I want to put use. It uses two port Parallel ports. X,Y at address 278, and A,Z at address 378.
My question is ,what Mach product do I use, and how do I set it up?
-
Im going to be totally honest with you on this.....
I too had a MAXNC older OL copntroller. It developed some minor issues. Finally got ahold of someone at MAXNC....... they wanted to sell me a whole new controller. Said that I could send in my box, they would look at it for $55 an hour. Most things take 3 to 4 hours to fix plus parts.... Or I could get a new controller (2005) model for $375.......
The run around I got with them......... ICK.....
So I ordered a new 4 axis xylotek controller.
But to answer half your question.......
I know Mach 2 should work for what your neededing, and I beleive Mach 3 will as well.
as for the setup....... Dunno as I have NIXED Maxnc