Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: budman68 on March 01, 2009, 03:12:50 PM
-
Hi guys,
I'd like to be able to use my taig mill and lathe on one PC. I know I can make different profiles for both machines but is it possible to use one of the parallel port switches like this?
(http://askbobrankin.com/lpt-switch.jpg)
Thanks for your time-
Dave
-
Dave,
Not a reason in the world it shouldn't work....
Regards,
Ray L.
-
Yup, should work fine.
Brett
-
Thanks so much, fellas-
Dave