Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: scottybev on February 28, 2009, 10:07:54 PM
-
Hey there folks.
I have been using Mach3 for 3 years now. I started from scratch with the help from Brian from New Fangled. 3 years later my computer told me to and crashed like a plane. I just bought a new computer that is built just for CAD. Fast as a fighter jet...
I have two PCI parallel ports that run a old Anaheim controller, but it works for me. I have BOBCAD V23. and still use V20.7.
What I need help with?
I purchased the M3 back in 2005 and that computer hard drive is toast. Do I need to repurchase it? Or can I re-down load it with out charge?
I know what do when the software is in the new computer.
I think I'm supposed to download the latest version of M3, is this true?
Anyone?
Thanks so much..
Scotty
-
Scotty, if you have your licenses file all you need to do is paste it in your Mach3 file on the new computer.
The latest Mach 3 will be fine. Just know there have been many changes in 3 years. Possobility some things won't work as before without some changes.
Brett
-
Scotty, if you have your licenses file all you need to do is paste it in your Mach3 file on the new computer.
What is the procedure of doing that? I'm a little rusty..
Thanks so much, I'm in big pinch and need to get some guitars run. Your a big help this time of the night bro.
Scotty
-
Scotty, I have sent you a personal message.
Brett