Machsupport Forum
G-Code, CAD, and CAM => G-Code, CAD, and CAM discussions => Topic started by: bfairey on February 27, 2009, 03:20:00 PM
-
Please see attached code
Brian.
-
You have not succeeded in attaching the code Brian.
Tweakie.
-
Thanks Tweaky but where do I attach the file?
Brian.
-
Hi Brian,
Click on 'Additional Options' then see 'Attach' use the 'Browse' to select the file (note only certain file types are allowed) then post.
Tweakie.
-
Please see what you can make of this
Brian.
-
You need to attach the g-code, not the .dxf
-
Hi Brian,
I don't know if you are cutting the part or engraving/drawing it. Assuming the profile was to be engraved I have converted your dxf to GCode (using Vistool 6) and the file is attached for you to look at.
Tweakie.