Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: haydn on February 24, 2009, 05:52:31 PM
-
Hi All,
Today I got a bag of proximity sensors, all new from the scrap yard for a few pounds. These are PNP normally open ones. I have a cambell breakout board which was designed to use NPN sensors. Anyone know if there is a way I can use them with this board?
Thanks
Haydn
-
Haydn, you could use some tiny reed relays and have the prox switches control the relays and the relays control your logic. Also, you may be able to use some transistors in the same fashion.
Brett
-
From page 10 of the BC - BOB....
-
Thanks for that, thats not in the manual version I have. Will give it a go.
Haydn