Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: ScrappyScooter on February 19, 2009, 12:42:56 PM
-
Is it possible to move an Axis in "relative" coordinates?
For example, If Y axis is at 70, I would like to enter -10 into the MDI that would move the axis to 60.
Thanks
Scrappy
-
I have found G91.
Thanks
Scrappy
-
Is it Possible to make the G91 temporary (for just the one move)?
SS
-
Is it Possible to make the G91 temporary (for just the one move)?
SS
Yes, just issue a G91, make the move, then issue a G90.
Regards,
Ray L.