Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: marty on December 24, 2005, 11:37:57 AM
-
HI ALL
NEED SOME HELP WITH WIRING MY NEW MPG
PINS NEEDED FOR +5V
PIN FOR OV
PIN FOR A
PIN FOR B
PRINTER PORT 2 IS IN PC
WILL ALL PINS BE ON PORT 2
-
You are going to have to find the 0 and 5 V power... Some of the breakout boards have the 5V power on them and some do not. I have hooked into the computer power supply in the past or testing...
The pins for the A and B channels can be hooked to what you have set on the ports and pins page. There is a tab called "Encoder" where you set the pins.
Hope that helps