Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: ScrappyScooter on February 15, 2009, 11:40:57 AM
-
I'm trying to repeat a program with the M47 command.
I put this at the end of my g-code.
The program rewinds to the beginning but stops. I have to click Cycle start to get in going again.
How do I use M47 to have it repeat without interaction from me?
Thanks
Scrappy
-
Depending on how long the code is but an M99 may be what your looking for.
Brett
-
It's just a few lines of code.
When I use M99 Mach3 hangs on a "please wait... generating path" window.
-
I added more lines of code and the M47 works now.
Thanks for the suggestion.
SS
-
NP, Thanks for the info. on M99. Will check that out later.
Brett