Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: mrpeja on February 10, 2009, 01:18:03 PM
-
I purchased brand new PC (2,3 GHz or something) and new PCI Parallel Port Card. After inserting card into slot, and starting PC BIOS doesn't see the card, and WIN XP also doesn't see it. (I think this is normally). After installing driver for this card, WIN does see it.
The question is: will Mach3 see the port #2 on so installed card?
Mrpeja
-
Yes, if its seen in Device manager then all you need to do is get the address for it from the resouces tab and tell Mach what that address is.
Hood