Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: subzero on February 09, 2009, 10:51:11 AM
-
Hi friends,
Can anyone please tell me if i can jog during operation. The problem is i do not have a THC and i just want to move up/down Z axis during plasma cutting.
Thanks
-
I have the same problem, some one to help us!!!
-
You can't jog, but you can use the THC Up/Down inputs. Just go to Port & Pin -> Mill Option and under THC Options, elect "Allow THC control even if not in THC mode". Now just make a remote with two buttons that activates the THC Up/Down inputs.
-
You can't jog, but you can use the THC Up/Down inputs. Just go to Port & Pin -> Mill Option and under THC Options, elect "Allow THC control even if not in THC mode". Now just make a remote with two buttons that activates the THC Up/Down inputs.
Thank you :)