Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: wjp9639 on February 09, 2009, 12:00:37 AM

Title: Vytek Rebel 4x8 cnc with nee amc3 controller (can mach3 drive this hardware)
Post by: wjp9639 on February 09, 2009, 12:00:37 AM

Does anyone know if mach3 can be setup to run this controller or if it can be setup to send jobs to this controller so i can run them directly from the amc3 controller? Mach3 seems to have good support on these forums so I would love to get it running properly. The controller is an amc3 from nee controls ltd. Here is the link: http://www.neecontrols.com/amc3.html Any help would be greatly appreciated and I would be willing to pay someont for their time If they can help me get it up and running somehow. Thanks again.

Jonathan
770-843-7111

Title: Re: Vytek Rebel 4x8 cnc with nee amc3 controller (can mach3 drive this hardware)
Post by: Hood on February 09, 2009, 08:04:18 AM

From initial looks at the website it seems it should be a fairly easy convertion. Will have a better look later and see.
Hood

Title: Re: Vytek Rebel 4x8 cnc with nee amc3 controller (can mach3 drive this hardware)
Post by: Hood on February 09, 2009, 02:23:13 PM

Having looked through the info (not great) it would seem it wont be so easy as I thought :(
If the drives and power supply from the control could be used then it would probably be the h=best way to proceed, if not then you would need to get new drives and breakout board to suit your steppers.
Hood