Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: tesart on February 06, 2009, 09:46:56 AM
-
I can't seem to find an OEM for a M5/spindle stop function. Does anybody know?
Thanks
Tom
-
Can't you just use Code "M5"?
-
I'm not sure? I am retrofitting a 1985 compumill and on the control panel there is a spindle stop button that I would like to hook up though Mach. The spindle CW and CCW buttons are are hooked up this way with OEMs so I can turn on the spindle from the control panel or the screen.(I can turn them off by pushing the button again, but would like to use the assigned button.)
Can I just put M5 in the OEM setup page?
Thanks
Tom
-
You can add a button to the screen, and assign M5 to it, and set up an OEM trigger for the external switch.