Machsupport Forum
General CNC Chat => Show"N"Tell ( What you have made with your CNC machine.) => Topic started by: budman68 on February 01, 2009, 04:21:03 PM
-
Thought I'd share my first project with MeshCam as I won this program over at the Taig Owners Club forum.
It's all new to me so it will take a little bit of playing with to get the hang of it and unfortunately time is pretty much non-existant lately.
My wife and I hate the commercialism of Valentines day so we always make each other cards instead of buying them. I thought this would be a nice addition to the card as well.
It's made from a piece of 2.5" by 5" X 3/8" Cherry and the full depth is about .120. I started with an 1/8 ballmill in .025 steps and then a finish cut of the same ballmill with .010 steps.
Not the most complicated part but I like to take babysteps! :D
Here's the pic that I stole the image from (obviously I had to modify it a bit and change it to grayscale):
(http://i63.servimg.com/u/f63/13/33/68/88/hearts10.jpg)
And then here's a couple of shots of the part:
(http://i63.servimg.com/u/f63/13/33/68/88/lisavd10.jpg)
(http://i63.servimg.com/u/f63/13/33/68/88/lisavd11.jpg)
-
Good Job Dave,
Brett
-
Looking good Dave,
RICH
-
Really nice work Dave.
Tweakie.
-
Thanks, fellas - :)
Dave