Machsupport Forum
Third party software and hardware support forums. => Third party software and hardware support forums. => Topic started by: bakeng on January 29, 2009, 12:03:42 AM
-
I have been looking at Mach3 and would like to use it on a Hardinge CHNC 1 Lathe I have. I dont like the idea of sending data through the parallel port. Is there anyone out there that makes a USB or better yet a PCI motion card that works with Mach3? Thanks.
-
Take a look in the PlugIn Download section. There, you will find all other controllers that operate with Mach at this time.
Steve
-
Dear sir
i am sai krishna from hyderabad INDIA i want the Operating system for Mech3 software i.e(PCB Circuit Board drives) which operates machine according commad given by Mech3.
Best Regards
Sai krishna
-
Hi Sai,
If you are using stepper motors there are a lot of cheap driver boards available from China.
Here is a link to just one supplier:-
http://stores.ebay.co.uk/I-Wanne-Buy-Shop
Tweakie.
-
Hi Bakeng,
Smooth Stepper is a first class USB to parallel port controller for Mach - although you will still need a stepper driver board as well.
Tweakie.
-
If you are looking for servo control with Mach3, check out the DSPMC controller at www.vitalsystem.com/dspmc