Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: DougO on January 27, 2009, 04:07:23 PM
-
Hate to keep bringing up the ShuttlePro but I think I have tried everything I have read to get it to work but I must be missing something. I installed the Shuttle software and then the Mach3 plug-in. Saw I was not supposed to installed Shuttle software, so I uninstalled it. When I go to Config:config plugins, the shuttlepro is installed with the green check to the left and the yellow "config" to the right. I click on the "config" button and see the ShuttlePro picture and associate the axis with the keys. Went back and exited Mach3 and then loaded Mach3 again. When I push the keys on the ShuttlePro, I just get a beep and the error message "Unknown word where unary operation could be.....". I am running Mach R2.63
Would appreciate any help, thanks
-
Hmmm...... I'm sure someone else will know how to help here but that sounds like something is definitely now corrupt. Have you tried reinstalling the plugin or reinstalling Mach3?
Always save a copy of your Mach3 XML file just in case.
Dave
-
Hate to keep bringing up the ShuttlePro but I think I have tried everything I have read to get it to work but I must be missing something. I installed the Shuttle software and then the Mach3 plug-in. Saw I was not supposed to installed Shuttle software, so I uninstalled it. When I go to Config:config plugins, the shuttlepro is installed with the green check to the left and the yellow "config" to the right. I click on the "config" button and see the ShuttlePro picture and associate the axis with the keys. Went back and exited Mach3 and then loaded Mach3 again. When I push the keys on the ShuttlePro, I just get a beep and the error message "Unknown word where unary operation could be.....". I am running Mach R2.63
Would appreciate any help, thanks
Is the plug-in supposed to work with R2.63? That's mighty old....
Regards,
Ray L.
-
That's actually a very valid point, Ray, thanks-
Dave
-
Thanks Dave. That did it.
I can't answer the question about working with R2.63. I went and downloaded R 3.042 and installed it with a new download of the ShuttlePro plugin and it's working fine now.
Thanks again for the help.
Doug
-
Excellent, glad it's working, it makes a great little pendant. :)
Dave