Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: mrmatt68 on July 20, 2006, 10:44:34 AM
-
when setting IPM in motor tuning to 1000 IPM axis will run at 1000 IPM but when i slave the Y axis the display shows 1440 ipm and no actual speed increase on that axis. Am I setting something wrong. Occurs in lockdown release. XYYZ machine configuration and the other axis seem to be fine.
-
the a-axis check box for angular is not checked either.......i don't know if this is just the way it works but seems like a bug to me. Also I am running the rutex 2020 drives if that make a difference. :)
-
hello
-
I was thinking that we fixed that one... I will tell Art about that when he gets back
thank you
Brian
-
ok thank you