Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: keithmech on January 21, 2009, 09:50:28 PM
-
ok this maybe a simple one; How do you print out a brain so that the size is
big enough to read?I work on my brains at my desk with a bread board
then when all seems well type it in to my machine.Thing is with short simple
stuff no problem but now some of these things are grOWING. ;)
-
Hi Keith,
One thing you can do is have a number of smaller Brains. Break it up into logical modules.
Remember that all the Brains are continuously run so lots of smaller Brains is better.
Cheers,
Peter.