Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Sweeney on January 20, 2009, 08:31:21 AM
-
This may not actually be a 'Mach' problem, more, a computer problem. On occasion, when I fire up my computer to tinker with my Taig mill I will have no Z axis control... it's just dead. The Mach DRO shows movement but I don't think the signal is getting to the machine power supply. Sometimes, rebooting will bring it back, sometimes it takes several reboots. Last night I gave up after a half dozen reboots. The diagnostics appear to check out as does the printer port. I've even tried wiggling the cable to see if I can get it to respond to no avail.
Any thoughts?
Cheers,
-
Do you have an enable signal for the Z drive from Mach? If you do then a voltmeter would soon tell you if its being applied, same with the Step and Dir signals, you could check to see they are coming out of the port.
Hood
-
Good idea. I do have an enable signal from Mach. I may just have a 'gamy' cable or port.
Thanks!