Machsupport Forum

Third party software and hardware support forums. => dspMC/IP Motion Controller => Topic started by: halkintool on January 13, 2009, 11:54:07 AM

Title: Axis works tuning graphs...
Post by: halkintool on January 13, 2009, 11:54:07 AM

When i execute a command with a graph, my results come up, i get a red line, a blue line and a green line.

However, where the text comes up on the left labelling the lines, all 3 layers of text are ontop of each other and i can't tell which position line is command and actual. Is there a newer version of axis works to correct this?

This is off the vital site and its obvious what color does what, but thought it could be looked at :)

(http://www.vitalsystem.com/web/motion/awgraph.JPG)

Title: Re: Axis works tuning graphs...
Post by: halkintool on January 13, 2009, 12:32:17 PM

Just so you know what im talking about.

Velocity is also spelled wrong...

Title: Re: Axis works tuning graphs...
Post by: Vital System Support on January 15, 2009, 01:14:02 AM

halkintool,

thanks for reporting this issue.  will get it fixed in the next release.

regards,
Rufi