Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: johnnydoughey on January 13, 2009, 01:41:05 AM
-
Is there a simple way to change the axis and cutting view in Mach3?
The directions do not match the actual machine directions and I would prefer changing the screen rather than switching driver connections...
Thanks in advance...
-
In which respect are you meaning that the view doesnt match the machine? If you are meaning the X moves the wrong way on your machineĀ then config menu then Homing and limits page will let you reverse the axis. The toolpath views on the screen are normal convention, X+ to the right and Y+ to the top for the mill/plasma etc and Z+ to right and Xzero to centre for Lathe.
Hood
-
Any time I've seen this question asked, it's turned out that the machine was set up incorrectly and actually moving in the wrong direction. Is X+ to the right and U+ up? Or are you using a non standard configuration?
-
Here's the scenario. I have my screen computer monitor positioned along side the longer (x) axis, so when I look at the monitor and over to the machine, it is the same direction. On my monitor, however, the X axis is showing horizontal. I just thought it would be nice to have the view on the monitor match the view when looking at the machine (vertical X axis)... no big deal, just thought it would be nice... I can understand the reasoning for the standard view.