Machsupport Forum

Third party software and hardware support forums. => Newfangled Solutions Mach3 Wizards => Topic started by: dacostad on July 17, 2006, 11:13:02 PM

Title: Problem with Cut Rectangle
Post by: dacostad on July 17, 2006, 11:13:02 PM

I am using version 1.90.065 of Mach 3 and keep getting errors when using the Cut Rectangle wizard.

I am running it twice to get two nested rectangles with the following settings

0.115 diameter tool
HSS
2 cutting tips
x position 0
y position 0
(in center of rectangles)
corner radius of .1
length of inner rectangle = 2"
width of inner rectangle = 0.75"
0 rotation
Conv mill
inner mill side for inner rectangle
pitch 0
rapid height 0.1
depth 0.27
step depth 0.1

for outer rectangle I use the same setting except for

length of rectangle = 2.5"
width of rectangle = 1.25"
outer mill side

When I run the wizard for the inner rectangle everything is fine, but then when I run it for the outer rectangle I get a Mach3Scripts message that says "Error on line 617 - Type Mismatch"  and then it brings up the VB scripts editor.

I suspect that I am probably doing something stupid as I am a total beginner at the Mill and CNC but it still probably should not be dealing with the error in the way it is.

Any suggestions.


Thanks

David

Title: Re: Problem with Cut Rectangle
Post by: Brian Barker on July 18, 2006, 11:46:23 PM

thank you David, I will be looking into it.

Title: Re: Problem with Cut Rectangle
Post by: dacostad on July 28, 2006, 01:29:55 PM

Any luck with this Brian?

Thanks

David

Title: Re: Problem with Cut Rectangle
Post by: Brian Barker on July 29, 2006, 08:11:10 PM

Fixed for the next rev

Title: Re: Problem with Cut Rectangle
Post by: dacostad on July 29, 2006, 08:21:27 PM

Any idea when that will be?

Thanks

David

Title: Re: Problem with Cut Rectangle
Post by: Brian Barker on July 29, 2006, 08:22:17 PM

I will ask Art :)