Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Hairball on January 03, 2009, 08:35:12 AM
-
I tried the new lockdown version of Mach3, R3.042.020, and found that it will not allow a correct Z start for the "Run From Here"
Option. It goes to the correct X and Y and then the Z moves into the positive direction until it reaches the Z+ limit. It seems to ignore the Z data in the program? Does any one else have this happen? I switched back to Mach 2.********* and ran my parts?
Danny
-
Sounds like you may be having issues with the safe Z position. Can you attach your xml and I will have a look.
Hood
-
Thanks Hood!
I changed the Safe Z to 1 inch and it fixed it!
-
Great and thanks for letting me know :)
Hood