Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Mr.Chips on January 01, 2009, 03:44:34 PM
-
When I started Mach3 Mill this morning the Mach3 screen was about 30% too large for my 17" monitor. For some reason it was way oversize. Haven't had this problem before.
Opened Mach3 Plasma and it filled the monitor screen normally.
How can I correct this? ???
Thanks
Hager
-
Go to Config menu then General Config and check the Auto Screen Enlarge option, it will shring your screen to fit your monitor.
Hood
-
I found the General Config and checkwd the Auto Screen Enlarge option, however even if I move that screen to the very top I can only see a portion of the OK. Tried clicking that but it doesn't resize the screen, is there something below the "OK" on the screen that I would need to click on but cannot see?
-
OK I got it.
Had to shut down Mach and restart then it was OK
Thanks.
-
you need top restart Mach after you have done the Auto Screen enlarge.
Hood
-
ah you got it while I was typing :)
Hood
-
Thanks Hood, I'm back in the game now.
Hager Hay