Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Robhi on January 01, 2009, 01:52:50 PM
-
Hi everybody,
happy new year to all of you.
I would like to know the function of disable in Gecko 201, Could I leave it alone and not connect it to any other wire?
What it is the advantage if I connect it (use it) and how could I use it?
thanks you and happy new year again.
Robhi :)
-
I know you dont need it as I never had it wired when I had G201's. I have G202's now with the same wiring but on them the disable pin says NC (No Contact I presume)
I would imagine the disable on the G201 would be so you could manually disable them from putting out any step pulses if you wished.
Hood
-
Hi Hood and all,
Thanks too much for your answer I appreciate that.
Robhi