Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Glenn on December 31, 2008, 02:58:24 PM
-
Hi guys,
Here's a message you don't want to see when clicking on
your desktop icon for Mach 3 Mill! :'(
" This application has failed to start because ATL71-DLL was not found.
Re-installing the application may fix this problem."
My system has been running GREAT but today, not so much...
Has anyone seen this problem or know of a solution before I try to re-install Mach?
Thanks,
Glenn
-
Have attached the ATL71 from my Mach folder, might be ok just to paste it in, if not then a reinstall should do it. You will need to change the file extension back from .txt to .dll as I changed it so the forum would accept it.
Hood
-
Thanks Hood!
I'm good as new, makin' some chips fly!
:) :D ;D
-
I'm good as new, makin' some chips fly!
:) :D ;D
Glad to hear that as I am getting dizzy watching you running round that tree, now you are back at your machine I should be ok.
Hood