Machsupport Forum
Third party software and hardware support forums. => Newfangled Solutions Mach3 Wizards => Topic started by: TDAY on December 31, 2008, 12:01:23 PM
-
Can Rectangle Wizard be made to do a outside Oval shape?Like the pic.
I tried and got a very odd round shape.
Thanks,
Troy
-
I dont think it works very well. I just tried a few examples and when the corner radius gets to big to fit within the rectangle strange things happen. Im not sure if this is a feature of the new cutter comp or it always worked like this. Im testing more now.
-
I think its always done this,as iam using Mach R3.038,and have tried this before.
Thanks,
Troy
-
actually if you check out the electrical wizard the duplex outlet cover hole is exactly that shape.
chuck
-
Ya,but i was doing a outside shape.And i need to be able to change the size of the oval.
Thanks,
Troy
-
Troy,
would it be practical to do a rectangle than a circle over it? or a circle than a rectangle to square the sides?
Chuck
-
Nice idea,but would be time consuming to run part.I would rather do the Gcoding with Cutter Comp.
I thought the Rectangle wizard could do it,as i have ran other CNCs that had a similar "wizard" that would do oval shapes also.
Thanks,
Troy