Machsupport Forum
Mach Discussion => Mach Screens => Topic started by: Jackal on July 15, 2006, 09:32:34 AM
-
Hello,
I downloaded a sample of MAch3 and The wizards work ok. But, when I save the g-code and go back to one of the main screens it is blank, with a line separating it . It sort of looks like a help section for a windows index. None of the operating screens will show at all and there is no selection buttons/tabs for the screens. I think that while messing with some of the settings it was changed. :o :o :o
After this first happened , I un-installed Mach 3 and re-installed it twice but it is still this way. The Lathe side works ok, it is just the MIll side. ??? ??? ??? ???
Thanks ,
Jackal ;D
-
Jackal,
Do you still have -"File, Config, View, Wizards, Operator, Help" at the top of Mach screen?
If so go to "View\Load screens" and choose the default Mach screen 1024.
It sounds like the wizard might have brought you back to an empty screen slot, not sure.
-
ALRIGHT!!!!!!!!!!!!!!!!!!!! That worked .
Thanks a million Zealouse!!!!
Jackal