Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Jon_sparky on July 08, 2006, 09:54:08 PM

Title: Rotary table makes erratic direction changes...
Post by: Jon_sparky on July 08, 2006, 09:54:08 PM

Hi all,
I have a sherline 4" rotary table that I am running on Mach 3. If I jog  forward twice it will reverse directions on me. Is this some setting I have wrong or is the motor wired wrong?
Jon

Title: Re: Rotary table makes erratic direction changes...
Post by: Brian Barker on July 08, 2006, 10:16:30 PM

I think you have one coil that is not getting power :(  Check your wires to the stepper motor

Title: Re: Rotary table makes erratic direction changes...
Post by: Jon_sparky on July 09, 2006, 01:00:21 AM

That would make sence. I'll check that out , thanks!
Jon