Machsupport Forum

Third party software and hardware support forums. => Third party software and hardware support forums. => Topic started by: dajavu on November 03, 2008, 11:55:49 PM

Title: C11 breakout board/trying to use the 110 AC Relay
Post by: dajavu on November 03, 2008, 11:55:49 PM

Can someone tell me which pin to use or how to configure Mach to use the 110 AC Solid State Relay?  It says pin one on it.  When i configure mach to use pin 1 is turns on and off the pin 1 which is located with the step / direction pins.  I will like to use an high speed Dremel tool and control it on/off with the program. 

Title: Re: C11 breakout board/trying to use the 110 AC Relay
Post by: Tweakie.CNC on February 06, 2009, 04:41:01 AM

Hi Dajavu,

The charge pump safety circuit for spindle control should be what you are looking for, here is the link:-

http://www.machsupport.com/docs/ChargePumpSafety.pdf


Tweakie.