Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: mannby on June 27, 2006, 03:53:01 PM

Title: Slider and touc hscreen problem
Post by: mannby on June 27, 2006, 03:53:01 PM

Hi, I have use a touch screen for a while now with Mach3 1.84
and now I downloaded the latest version 1.90.053 to try the slider.
But with my touch screen the slider for feed rate always change
back to 250% even if I use the mouse instead of touching the screen.
And when I try the same without the touch screen then the slider stayed as
I left it.
Have anyone tried the slider with a touch screen and got it working?

Roger

Title: Re: Slider and touc hscreen problem
Post by: Brian Barker on June 27, 2006, 07:22:48 PM

I will pass this on to Art :)

Title: Re: Slider and touc hscreen problem
Post by: mannby on June 29, 2006, 03:59:38 PM

Hi all,
my mistake, sorry about that.
I had the key grabber activated and one of the joystick axle was set to adjust
feed rate.
Sometimes I got very tired if myself.  :-[ 

Sorry again that I disturbed you guys.

Roger

Title: Re: Slider and touc hscreen problem
Post by: Brian Barker on June 29, 2006, 07:26:33 PM

No problem!  I have done the same thing :)